HOW TO MEASURE YOUR RING SIZE

Using a measuring tape is the best and most accurate method to determine your ring size. If this is not possible use the alternative method below with a paper strip.
Measure tightly where the ring would sit.
Keep in mind that your fingers may vary in size during the day due to temperature and humidity. Therefore, it is recommended to measure your finger at the end of the day, when it is likely the largest.
The same finger might differ in ring size for your left and right hand, make sure to measure the finger that you are planning to wear the ring on.
Ensure accuracy by measuring your finger three to four different times.

STEP 1: PLACE THE MEASURING TAPE

Place the measuring tape over your finger and pull it around into a circle.

STEP 2: ADJUST THE SIZE

Adjust the size of the circle, move it across your knuckles, and make sure it fits comfortably.

STEP 3: NOTE THE MEASUREMENTS AND FIND A SIZE

Take note of the measurements in millimeters and use the comparison chart below.

Ring Size Circumference (millimeters)	SIZE
47-49	5
49-52	6
53-55	7
56-58	8
59-61	9
62-63	10
64-66	11
67-69	12
70-72	13
72-75	14

ALTERNATIVE METHOD

1. Cut a strip of paper to wrap around your desired finger.

2. Wrap the piece of paper as tight as possible around your finger.

3. Mark the junction with a pen and measure the length of paper with a ruler.

NECKLACE SIZE CHART

The easiest way to measure necklace length at home is to grab a measuring tape and simply wrap it around your neck and adjust accordingly to your desired length. Alternatively you can use a piece of string or rope and measure the length with a ruler.